Evs MulticamLSM Version 10.04 - January 2011 Configura Manuel d'utilisateur télécharger pdf (Page 93)

EVS Multicam – Version 10.04 – Configuration Manual

EVS Broadcast Equipment SA – January 2011

Issue 10.4.A

3.20.9 IP ADDRESS

Possible value: xxx.xxx.xxx.xxx

When the Epsio connection is enabled via the External Offside parameter, the IP

Address of the Epsio workstation has to be entered in this parameter to allow the

communication between the EVS server and the Epsio workstation to be

established.

3.20.10 DEFAULT TOOL

Possible values: Offside (default), Arrow, Circle, Graphics

When the Epsio connection is enabled via the External Offside parameter, this

parameter specifies the tool to be activated by default in the Epsio menu on the

Remote Panel. It is recommended to keep the default value.

For more information on Epsio, refer to the Epsio user manual.

3.20.11 AUTO MARK

Possible values: Off / On (default)

When the Auto Mark setting is set to ‘On’, a cue point is automatically defined on

the record train every time the Epsio operator enters the Epsio menu on the LSM

Remote panel.

3.21 OVERVIEW

The XNet network is composed by several servers all connected with a

75-Ohm coaxial cable (BNC). The exchange between systems is operated through

the SDTI interface at 540 or 1485 Mbps.

The XNet network requires a network server dedicated to the management of the

database shared among all servers. This doesn’t require an extra server, but it

has to be assigned to 1 server on the network. If this system disconnects, another

server will automatically take over. These settings can be found in the

Configuration option of the EVS Maintenance menu. For details about the setup of

XNet network, please refer to the XT Tech Ref Hardware manual.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98

Pas de commentaire

Evs MulticamLSM Version 10.04 - January 2011 Configura Manuel d'utilisateur Page 93