Evs MulticamLSM Version 10.04 - January 2011 Configura Manuel d'utilisateur télécharger pdf (Page 56)

Issue

10.04.A

EVS Multicam – Version 10.04 – Configuration Manual

EVS Broadcast Equipment SA – January 2011

3.8.4 AUTO MAKE CLIP FOR CAM D

Possible values: Yes (default) / No

Make clip on CAM D even if no IN or OUT point has been marked on this one.

3.8.5 AUTO MAKE CLIP FOR CAM E

Possible values: Yes (default) / No

Make clip on CAM E even if no IN or OUT point has been marked on this one.

3.8.6 RESYNC TO TC REF

The Multicam application uses an internal table to reference all timecode

discontinuities detected on the LTC input of the system. This table is used to

match a recorded field to its timecode. When the number of TC discontinuities is

too important, a “!TC” warning appears on the OSD of the output monitors and the

system switches to the “internal timecode mode. The operator can clear the TC

discontinuities by calling the Resync to TC ref function. This function

synchronizes the internal TC to the timecode read on the LTC input of the server.

From that moment on, the system will assume that the timecode was continuous

for previously recorded material, and will take into account the new timecode

discontinuities.

Note that the above explanation is only valid for record trains. For clips, the

timecode of the first field of the clip is memorized at the creation of the clip, and

the timecode is always assumed continuous inside the clip. Clearing the internal

TC table will consequently have no effect on the timecode of recorded clips.

To call the Resync to TC ref function, simply press the F6 key. The function is

immediately performed and the message “TC resynchronization done”

is displayed.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 97 98

Pas de commentaire

Evs MulticamLSM Version 10.04 - January 2011 Configura Manuel d'utilisateur Page 56