Evs ENGSoft v1.5 User Guide Manuel d'utilisateur télécharger pdf (Page 25)

ENGSoft v1.5

This document is the exclusive property of OpenCube Technologies SAS and cannot be reproduced or distributed without prior authorization

25 / 63

10.5 XDCAM Planning support

10.5.1 Overview

Inadditiontotraditionalclipmetadata,theSONYXDCAMstandardcanprovideauser-definedmetadatasetcalledtheplan-

ningmetadataset.YoucantakeadvantageofthisfeatureinENGSoftbyenablingtheXDCAM planningsupportoption. 

Whenthisoptionisactivatedyoucanbrowse,mapandingestplanninginformationinENGSoftlikeanyothermetadataset.

Only  one  user- defined  planning  set  can  be  used  by  ENGSoft  at  a  time.  If  you  want  to  take  advantage of  your 

XDCAMmaterialplanningmetadatayoushouldstartbycarefullydefiningtheinformationyouwillneedtoaccessinyour

planningmetadataanddesignit.ThissetalonewillberecognizedasthevalidplanningsetbyENGSoft.Ifyouwantusto

help  you  design  the  planning  metadata  that  best  fits  your  workflow  needs,  contact  us  at

support_engsoft@evs.com.

10.5.2 Enabling XDCAM planning support in ENGSoft

AnXMLschemafilewillbedesignedforyourspecificneedsandshouldbeinstalledtocompletetheconfigurationofENG-

SoftandenableXDCAMplanningsupport.

After  you  install  the  application,  you  will  have  to  manually  copy  the 

"XDCAMPlanningSchema.xsd"  file  that  has  been  provided  with  your  software  installer  in  the 

"C:\ProgramData\OpenCube Technologies\OpenCube ENGSoft"folder.

Figure 36: Location of the XDCAMPlanning schema to enable XDCAM planning support

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 62 63

Pas de commentaire

Evs ENGSoft v1.5 User Guide Manuel d'utilisateur Page 25