Evs IPDirector Version 6.2 - June 2013 IPEDIT User Man Manuel d'utilisateur télécharger pdf (Page 231)

6.17. Using GPIs in IPEdit

6.17.1. General Information on GPIs

Basics

The GPI is the General Purpose Interface device that can be connected to the XT server.

The GPI signals, i.e. electric signals, generated by the GPI device allow the operator to:

• receive commands from a third-party device to the server. These are Input GPIs our

GPIs IN.

GPIs IN can be used in the Playlist panel.

• send commands from the server to a third-party device via given IPDirector

applications. These are Output GPIs or GPIs OUT.

GPIs OUT can be used in the Playlist panel and in IPEdit.

GPI Use in IPEdit

In IPEdit, you can define up to eight GPIs OUT. The IPEdit module and the Playlist panel

have to share these eight GPIs OUT.

Warning

IPDirector does not prevent the operator from using the same GPI OUT to the

Playlist panel and in IPEdit. This is up to the administrators and operators to

manage the use of GPIs OUT.

GPI and Slow Motion

When the speed of an element is different than 100%, you cannot add new GPIs to the

element or modify existing ones. However, you can delete the GPIs.

When you modify the speed of an element which already contained a GPI, the GPI

remains defined on the same TC as before.

Overview of GPI Settings

Each time you define a GPI, you need to specify the following settings:

GPI

Setting

Description Possible Values

GPI number Number of the GPI used From 1 to 8

GPI mode Type of electric signal used Pulse high,

Pulselow,

IPDirector- Version 6.2- User Manual- IPEdit

6. Timeline 219

1 2 ... 226 227 228 229 230 231 232 233 234 235 236 ... 263 264

Pas de commentaire

Evs IPDirector Version 6.2 - June 2013 IPEDIT User Man Manuel d'utilisateur Page 231