Evs XT2 Version 11.02 - July 2013 Configuration Manual Manuel d'utilisateur télécharger pdf (Page 169)

3.8.3. Tally Settings

Introduction

The Tally settings allow specifying the settings related to the tally feature. This feature

allows the user to automatically create a clip for each change of camera performed with

the Director’s Cut and to add these clips to a playlist. The clips are created automatically

by the server as it receives GPIs IN signals from a switcher when the director changes

the camera angle.

User Interface

These fields are available in the following interfaces:

• in the Multicam Configuration window, GPI tab

• in the Technical menu of the Remote Control Panel (T6.X)

The following screenshot presents the settings page of the Monitoring tab in the server-

based application and highlights the Tally settings area.

How to Activate the Tally Function

To use the tally function, proceed as follows:

1. Activate it using the Tally parameter.

2. Go to the GPIs IN settings area and select the GPI IN used for the tally control.

3. Set the Channel/Device on the REC on which the Director’s Cut is performed.

4. Set the function as Mark Tly.

CONFIGURATION MANUAL XT2 Server 11.02

3. Multicam Configuration 161

1 2 ... 164 165 166 167 168 169 170 171 172 173 174 ... 219 220

Pas de commentaire

Evs XT2 Version 11.02 - July 2013 Configuration Manual Manuel d'utilisateur Page 169